DIDI Posted January 9, 2009 Share Posted January 9, 2009 Witam mam taki problem kiedy importuje AI utworzony w corelu (jest to dokladnie rzut budynku z gory) to mam pewien problem z opcja extrude mianowicie mam zrobiony ksztalt scian z gory jednak po imporcie mam zamiast jednego obiektu kilka i nie moge wykonac funcji extrude prawidlowo bo nie mam tak jak byc domktnietych scian od gory, prosze o pomoc Link to comment Share on other sites More sharing options...
mirach Posted January 9, 2009 Share Posted January 9, 2009 A probowales weldowac te spliney ? Link to comment Share on other sites More sharing options...
DIDI Posted January 9, 2009 Author Share Posted January 9, 2009 to znaczy ?? a moze innaczej jak polaczyc wszystkie spline zeby byly jednym obiektem ?? nie chodzi mi przez opcje attach Link to comment Share on other sites More sharing options...
DIDI Posted January 9, 2009 Author Share Posted January 9, 2009 ok opcja weld pomogla dziekuje bardzo i przepraszam za pewnie dosc proste pytanie ale nie jestem najlepszy w 3d Link to comment Share on other sites More sharing options...
Recommended Posts