det Posted August 30, 2010 Share Posted August 30, 2010 witam,zaczałem modelowac moje pierwsze auto,zrobiłem same jakby umm ramki nadkoli,ucze sie z tutorialem.I w momencie kiedy chce polaczyc oba elementy funkcja bridge to nic sie nie dzieje.Robie tak jak w tutku,czyli najpierw oba elementy funkcja attach potem zaznaczam krawedzie i w momencie klikniecia bridge-nic.Mogłby mi ktos wytlumaczyc co robie zle?albo jak to zrobic zeby działało? Pozdrawiam Link to comment Share on other sites More sharing options...
mihpolak Posted August 30, 2010 Share Posted August 30, 2010 może spróbuj bridge z poziomu polygonów Link to comment Share on other sites More sharing options...
det Posted August 30, 2010 Author Share Posted August 30, 2010 tzn utworzyc poligony od tych krawedzi i dopiero wtedy bridge?:/ Link to comment Share on other sites More sharing options...
mihpolak Posted August 30, 2010 Share Posted August 30, 2010 tak wtedy przeciągnij ten poligon na drugi, leżący po przeciwnej stronie i utworzy się most. Link to comment Share on other sites More sharing options...
Recommended Posts