nielot007 Posted June 1, 2004 Share Posted June 1, 2004 Witajcie!! mam problem chce zrobic (zaraz dam zdjecia) rzecz robie spline i chce dac extrude ale chodzi o to zeby mi extrudowal tak zeby byla powierzchnia zamknieta (taki dach) jak nie wiecie o co chodzi to zdjecia moze pomoga prosze o pomoc jak widac na pierwszym princie sa spliny na drugim extrudowalem i chcialbym zeby gora byla zamknieta?? wiem ze moze (na pewno??) robie zle ale dopiero sie ucze w rhino jestem zielony wiec prosze o pomoc z gory dzieki Link to comment Share on other sites More sharing options...
SansSerif Posted June 1, 2004 Share Posted June 1, 2004 extrude > enter > c > enter Link to comment Share on other sites More sharing options...
Bzyku Posted June 1, 2004 Share Posted June 1, 2004 lepiej extrude >> b >> c >> end :) . Jesli wedlug tego tutoriala b >> c czy c >> b obojetnie w jakiej kolejnosci :D . przeciez tam jest wszystko napisane Link to comment Share on other sites More sharing options...
SansSerif Posted June 1, 2004 Share Posted June 1, 2004 B - to jest dwustronne extrudowanie, C - closed Link to comment Share on other sites More sharing options...
Bzyku Posted June 1, 2004 Share Posted June 1, 2004 nie nie C is cap :P, a \"b\" no jak both extrude wiec prawidlowa odpowiedz :D Link to comment Share on other sites More sharing options...
SansSerif Posted June 1, 2004 Share Posted June 1, 2004 cap czy slosed to to samo ;) nielot: czytaj opcje kazdej komendy w pasku. tam tez mozna klikac mysza. Link to comment Share on other sites More sharing options...
nielot007 Posted June 2, 2004 Author Share Posted June 2, 2004 dzieki wam i od teraz bede bardziej pocje kazdej komendy:D:D jeszcze raz dzieki Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now